Quick Jump Menu
Categories
There are no subcategories in this category.
1 #1 Vent-Free Issue - Nuisance Shutdown (or difficulty lighting) ODS Pilot Featured

This is common to all vent-free gas log sets, not just Rasmussen Chillbuster or Alterna VF sets. Before purchasing a replacement ODS, please read this article thoroughly - it may save you money and time. Testimonials : "Just thought you’d be interested…

2 Addendum for "S" Millivolt Safety Lighting Control for Vent-free Units

Addendum to Instructions for "S" Millivolt Safety Lighting Control Systems

3 My remote doesn't work

Q: My remote doesn't work. What do I do? A: 1) If it is a millivolt remote control, try the following: a) Replace the batteries in both the hand-held transmitter and receiver (black box). b) Be sure the valve knob is turned to the "ON" position. * Most of…

4 Pilot is too loud and noisy

Q - My pilot is very noisy and loud. How can I make it more quiet. A - All control valves have a pilot adjustment screw. Turning it clockwise will reduce the flow of gas to the pilot. The optimum adjustment is just before the point it makes noise. If adjusted…

5 RE-UP1 Installation Manual

RE-UP1 Installation Manual NOTE: Do not over tighten the motor drive to the gas valve. (Finger tip tighten only) Over tightening can cause the motor drive to get stuck inside the gas valve.

6 Removing Battery Cover from BPR3 Receiver (used with RE, SE, RMC1E, and RPK3)

Most of the battery packs open similarly, by pushing down and sliding the cover:

7 The pilot is lit but when I press the transmitter, the burner will not light. What is wrong and what do I need?

Q: The pilot is lit but when I press the transmitter (remote), the burner will not light. What is wrong and what do I need? A: Here are several things for you to check and try: 1) After lighting the pilot, did you turn the knob from the PILOT to the ON position?…