VEI Electronic Ignition System Won't Start
Author: Rett Rasmussen Reference Number: AA-05682 Views: 347 Created: 2020-12-01 15:19 Last Updated: 2020-12-01 15:20 0 Rating/ Voters

1-  Have you replaced the 4-AA batteries in the battery box?  If not, please do so. Ensure that the batteries are fresh (1.5 to 1.6VDC on a multimeter)

2-  If you replaced the batteries, was there any corrosion inside the battery box?  If unable to clean, you will need to replace the battery box, available at

Reset process, to synchronize the transmitter to the receiver:

1-  At the left side of the Valve Vanisher, at the receiver, press and hold the Reset button down.
      a) First you will hear a short beep,
      b) Continue to hold down until you hear a long beep, then release.

2-  Within ten seconds, press and release the Low Flame button on the Remote (You should hear two confirming beeps).

3- Start the lighting sequence normally, by simultaneously depressing the OFF and High Flame buttons until the beeping starts.

Rss Comments
  • There are no comments for this article.
Info Add Comment
Nickname: Your Email: Subject: Comment:
Quick Jump Menu
Info Ask a Question